SNJ54BCT541J

Active

Texas Instruments

BUFFER/LINE DRIVER 8-CH NON-INVERTING 3-ST BICMOS 20-PIN CDIP TUBE

Deep-Dive with AI

Search across all available documentation for this part.

DocumentsDatasheet SN54BCT541, SN74BCT541A datasheet (Rev. E)

SNJ54BCT541J

Active

Texas Instruments

BUFFER/LINE DRIVER 8-CH NON-INVERTING 3-ST BICMOS 20-PIN CDIP TUBE

Deep-Dive with AI

DocumentsDatasheet SN54BCT541, SN74BCT541A datasheet (Rev. E)

Specifications Pricing Series Description Documents

Technical Specifications

Parameters and characteristics for this part

Specification	SNJ54BCT541J

Current - Output High, Low	12 mA, 48 mA
Logic Type	Buffer, Non-Inverting
Mounting Type	Through Hole
Number of Bits per Element	8
Number of Elements	1
Operating Temperature [Max]	125 °C
Operating Temperature [Min]	-55 °C
Output Type	3-State
Package / Case	20-CDIP
Supplier Device Package	20-CDIP
Voltage - Supply [Max]	5.5 V
Voltage - Supply [Min]	4.5 V

5962-9074901 Series

Octal Buffers/Drivers With 3-State Outputs

Part	Number of Elements	Logic Type	Number of Bits per Element	Mounting Type	Current - Output High, Low	Voltage - Supply [Min]	Voltage - Supply [Max]	Package / Case	Supplier Device Package	Operating Temperature [Max]	Operating Temperature [Min]	Output Type
Texas Instruments 5962-9074901MRA
Texas Instruments SNJ54BCT541J	1	Buffer Non-Inverting	8	Through Hole	12 mA 48 mA	4.5 V	5.5 V	20-CDIP	20-CDIP	125 °C	-55 °C	3-State

Pricing

Prices provided here are for design reference only. For realtime values and availability, please visit the distributors directly

Distributor	Package	Quantity	$

Texas Instruments	TUBE	1	$ 36.88
		100	$ 32.78
		250	$ 26.95
		1000	$ 24.11

Description

General part information

5962-9074901 Series

The SN54BCT541 and SN74BCT541A octal buffers and line drivers are ideal for driving bus lines or buffering memory-address registers. The devices feature inputs and outputs on opposite sides of the package to facilitate printed-circuit-board layout.

The 3-state control gate is a 2-input AND gate with active-low inputs so that, if either output-enable (OE1\ or OE2\) input is high, all eight outputs are in the high-impedance state.

To ensure the high-impedance state during power up or power down, OE\ should be tied to VCCthrough a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.