STK531U394C-E Series

Intelligent Power Module (IPM), 600 V, 15 A

Catalog

Intelligent Power Module (IPM), 600 V, 15 A

Part	Technology	Features	Output Configuration	Current - Output / Channel	Package / Case	Mounting Type	Voltage - Supply [Min]	Voltage - Supply [Max]	Operating Temperature [Max]	Operating Temperature [Min]	Interface	Current - Peak Output	Load Type	Fault Protection	Applications	Supplier Device Package	Voltage - Load [Max]	Configuration	Current	Voltage	Type	Voltage - Isolation	Current - Output / Channel [custom]
ON Semiconductor STK531U369A-E	IGBT	Status Flag	Half Bridge (3)	10 A	29-SSIP Module 21 Leads Formed Leads	Through Hole	12.5 V	17.5 V	150 °C	-40 °C	Logic	20 A	Inductive	Current Limiting UVLO	AC Motors	29-SIP	450 V
ON Semiconductor STK531-392A-E
ON Semiconductor STK531U394C-E					29-SSIP Module 21 Leads Formed Leads	Through Hole												3 Phase Inverter	15 A	600 V	IGBT	2000 Vrms
ON Semiconductor STK531U390A-E
ON Semiconductor STK531U394A-E	IGBT	Status Flag	Half Bridge (3)		29-SSIP Module 21 Leads Formed Leads	Through Hole	12.5 V	17.5 V	150 °C	-40 °C	Logic	30 A	Inductive	Current Limiting	AC Motors	29-SIP	450 V						15 A
ON Semiconductor STK531-367A-E
ON Semiconductor STK531U340C-E

Catalog

Intelligent Power Module (IPM), 600 V, 15 A

Key Features

• Protective circuits including over current (bus line) and pre-drive low voltage protection are built in.

• Direct input of CMOS level control signals without insulating circuits is possible. (Active HIGH)

• A single power supply drive is enabled through the use of bootstrap circuits for upper power supplies. (externally set)

• Built-in simultaneous upper/lower ON prevention circuit to prevent arm shorting through simultaneous ON input for the upper and lower side transistors.(Dead time is required for preventing shorting due to switching delay.)

• The level of the overcurrent protection current can be changed with the external resistor "RSD" between the "ISD" and "VSS" terminals.

• Monitoring substrate temperature is possible through the use of an internal thermistor.

• Certification : UL Recognized (File number : E339285)

Description

This "Inverter IPM" is highly integrated power module containing all High Voltage (HV) control from HV-DC to 3-phase outputs in a single SIP module (Single-In line Package). Output stage uses IGBT / FRD technology and implements Under Voltage Protection (UVP) and Over Current Protection (OCP) with a Fault Detection output flag. Internal Boost diodes are provided for high side gate boost drive.